Unique Nail Cultivation System

Treatment Time - approx. 1 Hour

1. Spray your hands and your client’s hands with JESSICA Purely Clean Spray and preheat JESSICA Thermal Mittens ensuring the mittens are not touching each other.
2. Remove all traces of nail polish from the top and under each nail using JESSICA Polish Remover.
3. Perform a Nail Analysis and Consultation.
4. For the left hand, generously apply the following:

1. Phenomen Oil – Massage into the cuticle area and any other areas of dry skin.
2. Nourish Cuticle Cream – Massage into the cuticle area and any other areas of dry skin.
3. Hand & Body Moisturizing Emulsion – Massage any excess cream into the hand, continuing up to the elbow.
4. Wrap the left hand in cling film and place into the warmed Thermal Mittens for 5-10 minutes.

Electrically heated Thermal Mittens are deluxe part of the Manicure, and their use is strongly recommended at this stage. The warmth encourages essential vitamins and minerals to be absorbed more easily. Thermal Mittens increase penetration and are excellent for bad circulation and for rheumatic and arthritic  conditions.

1. For the right hand, repeat steps 4 a, b, c, and d.
2. Remove the left hand from the Thermal Mitten and massage the hand and arm up to the elbow and soak the nails in the Hand & Body Bath for a maximum of 2 minutes.
3. Repeat step 6 on the right hand.
4. Dry the hands and massage a small amount of Nourish into the cuticle area once more
5. Gently push back the cuticles with the Cuticle Attachment of the JESSICA Nail Care Machine.
6. Trim nails on the left hand and file gently in one direction only, then place the hand back in the water.
7. Repeat step 10 on the right hand.
8. Remove the left hand from the water and brush the nails briskly to remove all trace of cream and oil.
9. Gently push back cuticles using the wet corner of a linen towel to remove any loose dead skin.

Use the Brush Attachment on the Nail Care Machine around the nail area and behind the free edge to remove “frills”.

1. Gently nip any hangnails. DO NOT USE NIPPERS ON THE CUTICLES.
2. Repeat 12-13 on right hand.

STEP 1

• Using 8-10 strokes, generously apply 2 coats of appropriate Custom Basecoat or Corrective Treatment.
• Apply first coat under and over the nail, sealing the edges.
• Apply a second coat on the nail plate.

STEP 2

• Using 8-10 strokes, generously apply 2 coats of Custom Colour under and over the nail, sealing the free edge.
• Using 8-10 strokes, generously apply Top Priority, 1 coat under and over the nail, sealing the free edge.
• Using 8-10 strokes, generously apply Brilliance, 1 coat on the nail plate only, sealing the free edge.
• After 1 minute, apply 1 drop of Quick Dry to ensure against smudging.

NOTES: Remember to recommend the correct treatment schedule for your client.